SD Itanium - HP-UX 11.23 - Problem with memory (ILM/CLM)

[Rodrigo Albernaz]

I had in SD Itanium 4 nPars, each of which with an OS HP-UX 11.23. I change for 1 nPar only, as all hardware. I created 4 vPars in a single nPar, but I have problems with memory. When a created vPar, I create without seting ILM and CLM in vparcreate. I create default value.
Now I can not use the entire memory. The values ILM and CLM are different. What to do? Help me!

# vparstatus -A
[CPUs (path)]: 3.120
3.121
5.120
5.121
[CLP (CellID Count)]: 0 0
3 2
5 2
[Available CPUs]: 0

[Available I/O devices (path)]:

[Available ILM (Base /Range)]: 0x380000000/8064
(bytes) (MB) 0x578000000/112
0x4080000000/2048
[Available ILM (MB)]: 2048

[Available CLM (CellID Base /Range)]: 3 0x76180000000/6016
(bytes) (MB) 3 0x762f8000000/100
5 0x7a100000000/3968
5 0x7a1f8000000/112
[Available CLM (CellID MB)]: 0 0
3 6116
5 4080

[Duncan Edmonstone · Accepted solution]

The amount of ILM/CLM you have is controlled at the nPar level, not the vPar level - so how much do you have of both... run this on one of the effected vPars:

parstatus -Vp $(parstatus -wM)

to see ILM/CLM config for the nPar

and then run parstatus for each cell to see how much ILM/CLM you have in each cell board:

e.g. for cell 3:

parstatus -Vc 3

HTH

Duncan

[Rodrigo Albernaz]

I added one cell incorrect.
Thanks.