HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Start up Error

 
Ray Bell
Regular Advisor

Start up Error

I had the following error below in my /etc/log file and not sure what it mean. Should I be concern?

Initialize Instant Capacity
Output from "/sbin/rc2.d/S602icod start":
----------------------------
ERROR: The following low-level error occurred:

PGS08000: CIM HTTP or HTTPS connector cannot connect to local CIM server. Connection failed.
ERROR: /etc/inittab is missing the required entry for the Instant Capacity daemon (icapd).
Refer to the icapd (1m) man page for more
information.

ERROR: The following low-level error occurred:

PGS08000: CIM HTTP or HTTPS connector cannot connect to local CIM server. Connection failed.
ERROR: The Instant Capacity (iCAP) Agent was unable to reconcile the number of active processors with the intended number of active processors. For further information about the Instant Capacity status, run icapstatus (1m).
"/sbin/rc2.d/S602icod start" FAILED
1 REPLY
Jim Walls
Trusted Contributor

Re: Start up Error

You should be concerned if you rely on Instant Capacity on Demand (B9073BA iCOD a.k.a iCAP).

You should also have the WEBMServices package (and its various dependencies).

check to see if you have this line in /etc/inittab

cim1:3456:respawn:/opt/wbem/lbin/cimserverd

man icap
man cimserver
man cimserverd