HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

Syatem creshed during boot time.

 
sur_hp
Occasional Contributor

Syatem creshed during boot time.

Hi,
My system crashed during boot time with following messages :-

Stored message buffer up to system crash:
Module btlan is put into ramfs:load time: driver_install, state: loaded
Module procsm is put into ramfs:load time: driver_install, state: loaded
Module c8xx is put into ramfs:load time: driver_install, state: loaded
Module cdfs is put into ramfs:load time: driver_install, state: auto
Module cfsmdr is put into ramfs:load time: driver_install, state: auto
Module cfsm is put into ramfs:load time: driver_install, state: auto
Module cifs is put into ramfs:load time: driver_install, state: auto
Module fcd is put into ramfs:load time: driver_install, state: loaded
Module td is put into ramfs:load time: driver_install, state: loaded
Module gelan is put into ramfs:load time: driver_install, state: loaded
Module iether is put into ramfs:load time: driver_install, state: loaded
Module igelan is put into ramfs:load time: driver_install, state: loaded
Module lvmp is put into ramfs:load time: driver_install, state: loaded
Module ciss is put into ramfs:load time: driver_install, state: loaded
Module mpt is put into ramfs:load time: driver_install, state: loaded
Using /stand/ext_ioconfig
gate64: sysvec_vaddr = 0xc0002000 for 2 pages

Memory Class Setup
-------------------------------------------------------------------------
Class Physmem Lockmem Swapmem
-------------------------------------------------------------------------
System : 7790 MB 7790 MB 7790 MB
Kernel : 7789 MB 7789 MB 7789 MB
User : 7420 MB 6652 MB 6678 MB
-------------------------------------------------------------------------

ktracer is off until requested.
Installing Socket Protocol families AF_INET and AF_INET6
64000/0xfa00 esvroot
Kernel EVM initialized
64000/0x0 mass_storage
64000/0x0/0x0 usb_ms_scsi
bad_kern_reference: 0x1cc5b400.0x400003ffffff1021, fault = 0xf

Message buffer contents after system crash:

linkstamp: Fri Apr 09 13:19:34 MDT 2010
_release_version: @(#) $Revision: vmunix: B.11.31_LR FLAVOR=perf
panic: Fault when executing in kernel mode

PC-Offset Stack Trace (read down, top of stack is 1st):
0x00868fe8 ()
0x009b3d0c ()
0x000afc20 ()
0x008ac5a8 ()
0x008a333c ()
0x00a3927c ()
0x00a543b4 ()
0x00a54f28 ()
0x00a48514 ()
0x004d01e0 ()
0x004d0838 ()
0x004d1050 ()
0x00375780 ()
0x003755bc ()
0x008f7a50 ()
0x00438518 ()
0x008a3b00 ()
0x001441b8 ()
End Of Stack
shutdown : Failed to halt all processors


i 0 pfn 0x0 pages 0x40000
i 1 pfn 0x100000 pages 0xffe00
i 2 pfn 0x4040000 pages 0xc0000

*** A system crash has occurred. (See the above messages for details.)
*** The system is now preparing to dump physical memory to disk, for use
*** in debugging the crash.

ERROR: Your system crashed before I/O and dump configuration was complete.
A crash dump cannot be taken under these circumstances without
special configuration. Contact your HP support representative.

Can any one please help me for figuring out what happened to my system.

3 REPLIES
Robert-Jan Goossens
Honored Contributor

Re: Syatem creshed during boot time.

Hi,

http://www13.itrc.hp.com/service/cki/docDisplay.do?docId=emr_na-c01374040-1&docLocale

Title: HP-UX 11i v3 - Panic while Booting after Installing September 2007 11i v3 patch Media
Document ID: emr_na-c01374040-1

Regards,
Robert-Jan
sur_hp
Occasional Contributor

Re: Syatem creshed during boot time.

I have HPUX11iv3 0903 installed in my system.
Taifur
Respected Contributor

Re: Syatem creshed during boot time.

Hi,

This error belongs to hardware related error , so Check MP log

MP>SL----F--d (Y)
MP>SL----E---d (Y)
MP>CM>SS

Cheers,
Taifur