Tape device no more recognized

[tennis player]

Hello,

I work on a HP-UX B.11.11 U 9000/800 machine.

There's a SCSI connection between the server and the tape device which is external.

We unplugged the connection and plugged it again. Now the tape device is no more visible.
And I cannot use it of course.

How can i check/reconfigure it?

Thanks a lot,

Stefano

[R.O.]

Hi,

Reboot the server with the tape connected to it.

Regards,

[tennis player]

It was the first thing I tried but did not get any improvement...

[R.O.]

Hi,

Is it the tape device online? What is the result of "ioscan -fnCtape"?

[Suraj K Sankari]

Hi,

Check the cable is it ok or faulty? replace the cable and check..
Check the tape drive into other server is it visible there ? if yes that means cable is ok
conncet to your system and do a "insf -e"
then check with ioscan -fnC tape

if still not visible then reboot your server.

Suraj

[S-M-S]

iN 11I v1, There is no reboot require for detecting your scsi Drive..
Do what exactly Suraj suggested and try to isolate the issue

[tennis player]

I performed all the actions you suggested apart from the cable check (I'm pretty sure it is not damaged).

In spite of all I still cannot see the tape device.

Output of ioscan -fnC tape is void.

I'm going insane :)

[Bill Hassell]

> Output of ioscan -fnC tape is void.

I don't remember the word void anywhere in ioscan. What is the result of this command:

ioscan -fnC tape

[tennis player]

The command exits giving no answer, which means it does not find any tape device I guess...

[Torsten.]

If you connect or disconnect an active SCSI bus there is a good chance to produce a glitch and destroy hardware.

For exactly this reason you should always power off the server and tape before touching the cable that way.

As long as no hardware is damaged, some pins can be bent. This happens often with the evil 68 pin connectors - 2 pins together in 1 hole.

This can again kill the hardware.