HPE Community
Operating System - HP-UX
1753569 Members
5900 Online
108796 Solutions
New Discussion

Re: The specified path does not correspond to physical volume attached to volume group

 
Torsten.
Acclaimed Contributor

‎10-30-2009 06:38 AM

‎10-30-2009 06:38 AM

Re: The specified path does not correspond to physical volume attached to volume group

Any recent changes? Disk replaced?

What the status of the disk now?


# sasmgr get_info -D /dev/sasd0 -q raid

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎11-02-2009 01:30 AM

‎11-02-2009 01:30 AM

Re: The specified path does not correspond to physical volume attached to volume group

>> Cur PV 2
Act PV 1



On what thread should we continue now?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.