HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Showing results for 
Search instead for 
Did you mean: 


A.G.M. Velthof
Valued Contributor


I want to connect my rx2660 to our netapp storage with iscsi.
I have 2 lan ports connected to a vlan where the netapp also is in.
Both of the cards have ip addresses in the same network.

What port will be used now and how do I see that?

Can I make an aggregate for these two card and how do I do that?

Thanks in advance.
Respected Contributor

Re: aggregation

Yes u can make auto port aggregate for these two cards.
Both of the card should be in different vlan,
Check the linkloop test of both the lan cards.
OS should be HPUX 11iV3 or V2
Install the APA depot and configure.

Please refer below thread

Hope this solves ur query

Vishnu Khandare
You should deserve before U desire!!!!