HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

boot rp4440

 
SOLVED
Go to solution
A.G.M. Velthof
Valued Contributor

boot rp4440

Helo to all.

 

We want to boot our rp4440 system from the primary Path, but got a message "cannot execute /stand/vmunix"

 

The alternate boot Path  works fine.

 

Both disks should be complete mirrors.

 

The output from lvlnboot -v is:

 

Boot Definitions for Volume Group /dev/vg00:
Physical Volumes belonging in Root Volume Group:
        /dev/dsk/c2t1d0 (0/1/1/0.1.0) -- Boot Disk
        /dev/dsk/c3t0d0 (0/1/1/1.0.0) -- Boot Disk
Boot: lvol1     on:     /dev/dsk/c3t0d0
Root: lvol3     on:     /dev/dsk/c3t0d0
Swap: lvol2     on:     /dev/dsk/c2t1d0
                        /dev/dsk/c3t0d0
Dump: lvol2     on:     /dev/dsk/c2t1d0, 0

 

What does the /dev/dsk/c2t1d0 miss?

 

Best regards, Alfons

2 REPLIES
Patrick Wallek
Honored Contributor
Solution

Re: boot rp4440

There may be a problem with the primary disk or the  mirrors may have gone a bit flaky.

 

I would start by removing all mirrors from the c2t1d0 disk, remove the disk from the VG, and then remirror completely from scratch

A.G.M. Velthof
Valued Contributor

Re: boot rp4440

Hello Patrick,

 

as suggested, reconfigured the volume group and it works again...

 

Thanks, Alfons