command for HBA

[Eli Daniel]

good afternoon,
now I have an HBA card with this status:
Driver state = AWAITING_LINK_UP

That command I can use to reset the card?
fcmsutil-f enable? this work?

operation system: HP-UX 11.23

P.S. This thread has been moved from Disk to HP-UX > sysadmin. -HP Forum Moderator

[singh sanjeev · Accepted solution]

check the FC connection..is everthing fine. physical check is required

[Svetoslav Gyurov]

Hi Daniel,

If you want to reset the card you should use:
fcmsutil /dev/CARD reset

where CARD is your fibre channel card.

It can be found with the following command:
ioscan -fnkCfc

Just make sure that your port at the switch is enabled and I also kindly advice you to set explicitly the port speed (2/4/8Gbps) at the side of the switch!


Regards,
Sve

[Eli Daniel]

yes, the physical connection is OK HBA.

I need to restart the HBA card to verify whether active or not.

[John Guster]

On the server side, the HBA is ready to be used, ask the SAN storage team to turn link on.

[Steven E. Protter]

Shalom,

If lights are lit and fcmsutil is still in the state listed above:

1) Possible problem on the fiber network
2) Fiber switch may need to be configured to an online status.

The HP-UX serve should pick up this status instantly without need to reboot.

SEP

[Eli Daniel]

Exactly, I will not restart the operation system, I reset the HBA card

[Eli Daniel]

when performing this activity must be down systems?

[Steven E. Protter]

Shalom,

No, to reset the HBA card when it is not ONLINE does not require a down system.

I would not reset the HBA card while ONLINE and having file systems mounted on disks it provides.

In the current situation, no downtime appears to be required.

SEP

[Benoy Daniel]

Do an ioscan -fnC fc and get device file for that particular card.

then do a fcmsutil command to reset the HBA

/opt/fcms/bin/fcmsutil -f reset