cancel
Showing results for 
Search instead for 
Did you mean: 

cpuinfo

whiz_kid911
Frequent Advisor

cpuinfo

i hv a rx8640 with multiple npars, with montecito and montivale

i am planning for an upgrade, and wanna find out cpu if its montecito or montivale for each npar

how can i find this out from hpux

 

2 REPLIES
Turgay Cavdar
Honored Contributor

Re: cpuinfo

Type "machinfo" command, when you see "Itanium 2 9100 series processor" then this is "montvale".

 

Regards...

Robert_Jewell
Honored Contributor

Re: cpuinfo

...and conversly the Montecito CPU's will report as 9000 series:

 

# machinfo
CPU info:
  4 Intel(R) Itanium 2 9000 series processors (1.4 GHz, 12 MB)
          400 MT/s bus, CPU version A2/B0'
          8 logical processors (2 per socket)

Also, from outside the OS you can use the MP's DF command to display CPU information.

 

For example:

MP:CM> DF, S, X (enter CPU slot)

 

Look for the FRU Name entry.  THe following shows the above Montecito CPU.

    FRU Name                       : MONT_B0'

 

Montvale CPU's are shown as MTV_xx (or similar).

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!