System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

emx3 Sequence Manager Fatal Error

Carlos A. Munoz Lopez
Frequent Advisor

emx3 Sequence Manager Fatal Error

Hi guys! I'm experiencing a problem with a fibre channel interface. When I check the logs in /var/adm/messages I can see

vmunix: emx3: ***** HARDWARE ERROR *****
vmunix: status 0x20000000, 0xA8=0x000172c4, 0xAC=0x50000003: HW ERR(ER3):Sequence Manager Fatal Error

The error is intermittent. When I check the adapter status with hwmgr, this is what I get:

ADAPTER LINK LINK FABRIC SCSI CARD
HWID: NAME STATE TYPE STATE BUS MODEL
--------------------------------------------------------------------------------
73: emx3 up point-to-point attached scsi6 KGPSA-CA

There's no information regarded to this problem in the binary logs. As you can see the link state is up. I checked the storage but there's no error in it. I've been searching on internet but I can't find any information related to this. I don't know if the interface should be replaced. I would like some help on this. Thanks in advance.
1 REPLY
Carlos A. Munoz Lopez
Frequent Advisor

Re: emx3 Sequence Manager Fatal Error

I forgot, this is the information on the adapter:


ADAPTER LINK LINK FABRIC SCSI CARD
HWID: NAME STATE TYPE STATE BUS MODEL
--------------------------------------------------------------------------------
73: emx3 up point-to-point attached scsi6 KGPSA-CA

Revisions: driver 2.17 firmware 3.91A1
FC Address: 0x11000
TARGET: -1
WWPN/WWNN: 1000-0000-c924-a3d6 2000-0000-c924-a3d6

Tru64 5.1B PK5