hszterm tru unix 5.1a hsz40/50

[Michael Schulte zur Sur]

Hi,

when I use hszterm on a cluster with hsz50 I get the following error:

fra01d /> scu show edt

CAM Equipment Device Table (EDT) Information:

Bus/Target/Lun Device Type ANSI Vendor ID Product ID Revision N/W
-------------- ----------- ------ --------- ---------------- -------- ---
0 1 0 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 1 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 2 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 3 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 4 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 5 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 1 6 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 3 1 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 3 2 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 3 3 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 4 1 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 4 2 Direct SCSI-2 DEC HSZ50-AX V57Z W
0 4 3 Direct SCSI-2 DEC HSZ50-AX V57Z W
1 2 0 Sequential SCSI-2 DEC TZ89 (C) DEC 2561 W
1 5 0 Sequential SCSI-2 DEC TLZ10 (C) DEC 04a8 N
3 0 0 CD-ROM SCSI-2 COMPAQ CD-224E 9.5B N

fra01d /> hszterm -b 0 -t 3 -l 1
HSZterm: Error on RAID services open: No such device or address.fra01d />

The same works on hsz40 at a single machine.

Does anyone know why?

thanks,

Michael

P.S. This thread has been moved from Storage > General to Tru64 > sysadmin. - Hp Forum Moderator

[Arnaud Veron · Accepted solution]

i think you should give a try to :

/usr/lbin/hsxterm5 -b 0 -t 3 -l 1

[Michael Schulte zur Sur]

Hi,

thanks, I wasn't aware, there was a new version. It works.

Michael