qdiks cannot come online automatically

[rhel6_cluster]

For node-1
[root@PDC-PIC-PL-01 ~]# clustat
Cluster Status for PDC-PIC-CL @ Fri Sep 14 14:21:52 2012
Member Status: Quorate

 Member Name                                      ID   Status
 ------ ----                                      ---- ------
 PDC-PIC-PL-01                                        1 Online, Local
 PDC-PIC-PL-02                                        2 Online
 /dev/block/253:9                                     0 Online, Quorum Disk

For Node-2
[root@PDC-PIC-PL-02 ~]# clustat
Cluster Status for PDC-PIC-CL @ Fri Sep 14 14:32:18 2012
Member Status: Quorate

 Member Name                                  ID   Status
 ------ ----                                  ---- ------
 PDC-PIC-PL-01                                    1 Online
 PDC-PIC-PL-02                                    2 Online, Local


While starting cman:

[root@PDC-PIC-PL-02 ~]# service cman status
qdiskd is stopped

and my /var/log/messages shows:


Sep 14 14:22:05 PDC-PIC-PL-02 qdiskd[17722]: Unable to determine qdiskd votes automatically
Sep 14 14:22:05 PDC-PIC-PL-02 qdiskd[17722]: Configuration failed

Can you help me how to make qdisk online?

Thanks!

[Ralf_S]

Hello Advisor,

is your qdiskd running?

what entries do you have from clurgmgrd, qdiskd and cman in messages and other logfiles of the cluster?

Do you defint

votes="1" in your cluster.conf for each node AND the quorum disk?

Bye

Ralf

[Chhaya_Z]

Hi,

Is this a new cluster setup?

Could you please check if you have set all the Quorum-Disk Parameters correctly? Please check the below point:

"The minimum score for a node to be considered "alive". If omitted or set to 0, the default function, floor((n+1)/2), is used, where n is the sum of the heuristics scores. The Minimum Score value must never exceed the sum of the heuristic scores; otherwise, the quorum disk cannot be available."

[faruqhp]

HI

I have Configured  two node Cluster in RHEL 6.3 . Cluster is runing smothly and  I also configure Power Fencing using HP ILO4(IPMI LAN).

When I disconnect the node1 Heartbeat then node1 httpd service switch to node2 succssesfully. But when I disconnect the power cord from node1 then node1 httpd service status started but not switch node2 succesfully .when I connect the Power cord  node1 then trnasfer the httpd service node2 successfully.

Regards,

Faruq