HPE Community
Operating System - HP-UX
1753340 Members
5445 Online
108792 Solutions
New Discussion

Re: rp8400 - 11.11 - root disks show 100% used

 
SOLVED
Go to solution
Nick W
Frequent Advisor

‎02-15-2008 03:07 AM

‎02-15-2008 03:07 AM

Re: rp8400 - 11.11 - root disks show 100% used

moonchild,

In addition to the previous advice to look at your IO layout, perhaps you are swapping...? Check the output from "swapinfo -mat" - look on the 'dev' line: anything >0% means you are swapping (perhaps your swap area is on these disks...?) - would also make sense with your statement "commands that are hanging"
If swapping to disk, then consider these 2 options: buy more (memory) or do less (adjust work profile)


Hope this helps

Regards,
Nick 'dubya'
Reply
moonchild
Regular Advisor

‎02-15-2008 03:14 AM

‎02-15-2008 03:14 AM

Re: rp8400 - 11.11 - root disks show 100% used

correct swap is on vg00 but swapinfo which is attached, shows no swaping.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.