stm not functioning.

[點燃]

Hi
I'm facing a problem related to stm.
Whenever I'm running the command "map" at the 'cstm>' prompt, it diaplays the following error.

cstm>map
* * * N O C U R R E N T S Y S T E M * * *

Thanks!

[Taifur · Accepted solution]

Hi Pradeesh,

If you facing problem with cstm ,then you can run nickel script, from where you can check all of the information about your system.

#cd /opt/contrib/bin
#ll
#./nickel

Rgds//
Taifur

[Torsten.]

You will see no map if the system is scanning.

Just try to stop and start the diags again.

# /sbin/init.d/diagnostics stop

[Vinoyee Madashery Poulo]

Pradeesh,

Stop and start the diagnostic daemon and wait for some time to regenrate the maping.

/sbin/init.d/diagnostic stop
/sbin/init.d/diagnostic start

[點燃]

Hi All,
Thanks for the replies,
I've restarted 'diagnostic' and was able to run 'map' successfully, but when I tried to select a device, I could not do that.
It has come to the cstm prompt suddenly after that.Any suggestions?

[Torsten.]

Once started, it needs some time to scan.

What version are you running?

Just starting cstm will tell you ...

[點燃]

-- Information --
Support Tools Manager


Version A.59.05

Product Number B4708AA

[Torsten.]

Looks like a currently supported version.

How do you select the device?

Just to check this: Does your name resolution work correctly?

[點燃]

Hi
The daemon '/usr/sbin/stm/uut/bin/sys/diagmond'
is getting started whenever I restart diagnostic, but disappear after a while.
The name resolution works normally.

thanks!

[點燃]

Closing this thread.
The issue was that, the 'nfiles' parameter had overflown. A reboot did fix the issue.

Thanks for all the help!

cheers,
Pradeesh kumar.