System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

tg3: eth0: Flow control is off for TX and off for RX

Andre Wyss
Occasional Visitor

tg3: eth0: Flow control is off for TX and off for RX

Hello
I can not link to the router.
I have found that many google the "broadcom ethernet" mentioned.
Is there the possibility that they explain to me how I could solve this problem for a ProLiant ML 110 G4 with a
06:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 21)
tg3: eth0: Link is up at 100 Mbps, full duplex.
tg3: eth0: Flow control is off for TX and off for RX.
System - Debian 4
5 REPLIES
Rob Leadbeater
Honored Contributor

Re: tg3: eth0: Flow control is off for TX and off for RX

Hi,

What exactly is your problem ?

The "Flow control" message looks like an informational message to me. I very much doubt that it is the cause of your problem.

Cheers,

Rob
Andre Wyss
Occasional Visitor

Re: tg3: eth0: Flow control is off for TX and off for RX

The problem: right after the installation comes - tg3 eth0: Link is up at 100 Mbps, full duplex.
Tg3 eth0: Flow control is off for off for TX and RX.
I am looking for an answer why there is no access to the server. SSH everything ok he not only listens on www.side.com
Rob Leadbeater
Honored Contributor

Re: tg3: eth0: Flow control is off for TX and off for RX

That is not a problem. It is an informational message telling you that the network link is up and that flow control is off.

If you can SSH to the server, then the network is working.

Please tell us exactly what you are trying to do, and exactly what doesn't work... "no access to the server" could mean anything...

Cheers,

Rob
AnkitJ
Occasional Visitor

Re: tg3: eth0: Flow control is off for TX and off for RX

Hello,
I am facing same problem in ML 110 G5.
Because of this my nfs server is running slow.
System - OpenSUSE 10.2 64 bit

Please help
Rob Leadbeater
Honored Contributor

Re: tg3: eth0: Flow control is off for TX and off for RX

Please start a new thread.

Cheers,
Rob