HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

the NIC card name and type

 
niftysw
Occasional Contributor

the NIC card name and type

Hi there,

Is it possible to get the informaton of the NIC card name and type on HP-UX command?

Best regards,
2 REPLIES
nijokj
Trusted Contributor

Re: the NIC card name and type

ioscan -fnC lan will provide you the lan card information and corresponding LBA information.

alternate if cstm working on your server selct the device and check the info log will provide you all lan card information.
Ismail Azad
Esteemed Contributor

Re: the NIC card name and type

Hi,

The "subsystem" and "interface type" would be present in your nwmgr output as well.

Regards
Ismail Azad
Read, read and read... Then read again until you read "between the lines".....