System Administration
cancel
Showing results for 
Search instead for 
Did you mean: 

vpar crash after DRD patching

EU-Admins-UNIX
Regular Advisor

vpar crash after DRD patching

HI

 

I used DRD to patch a clone disk and rebooted the vpar (not the first time I have done this).

 

The vpar has now crashed and won't boot.  I have tried to set the ALT path to all paths to boot to the alternate, but nothing.

 

Even tried to boot from tape, but not working.

 

It won't even boot to the original root disk.

 

Any ideas will be most welcome.

 

Regards

 

Tariq

2 REPLIES
Patrick Wallek
Honored Contributor

Re: vpar crash after DRD patching

What kind of error messages are you getting?

EU-Admins-UNIX
Regular Advisor

Re: vpar crash after DRD patching

VPAR: sba_info - rc=0 base=0xffffff8020000000 shared=1 cnt=2

VPAR: sba_info - rc=0 base=0xffffff8120000000 shared=1 cnt=2

DoCalllist done

 

Stored message buffer up to system crash:

ether5: INITIALIZING HP A7012-60001 PCI/PCI-X 1000Base-T Dual-port Adapter at hardware path 1/0/12/1/0

iether6: INITIALIZING HP A7012-60001 PCI/PCI-X 1000Base-T Dual-port Adapter at hardware path 1/0/12/1/1

iether7: INITIALIZING HP A7012-60001 PCI/PCI-X 1000Base-T Dual-port Adapter at hardware path 1/0/14/1/0

iether8: INITIALIZING HP A7012-60001 PCI/PCI-X 1000Base-T Dual-port Adapter at hardware path 1/0/14/1/1

afinet_prelink: module installed

Starting the STREAMS daemons-phase 1

AF_INET socket/streams output daemon running, pid 47

LVM: Root VG activated

    Swap device table:  (start & size given in 512-byte blocks)

        entry 0 - major is 64, minor is 0xc0002; start = 0, size = 16777216

    Dump device table:  (start & size given in 1-Kbyte blocks)

        entry 0000000000000000 - major is 1, minor is 0x4; start = 1837920, size = 8388608

vconsd: exited

vconsd: exited

VFS_MOUNTROOT error information:

0:(hfs) 22

1:(nfs) 223

9:(vxfs) 28

10:(nfs3) 223

11:(nfs4) 223

12:(autofs) 251

15:(cifs) 223

18:(dnlc_neg_fs) 251

 

Message buffer contents after system crash:

 

linkstamp:          Fri Apr 19 12:55:01 BST 2013

_release_version:   @(#) $Revision: vmunix:    B.11.31_LR FLAVOR=perf

panic: VFS_MOUNTROOT: RDWR: all VFS_MOUNTROOTs failed: NEED DRIVERS ?????

 

PC-Offset Stack Trace (read down, top of stack is 1st):

 0x10974040 (panic+0x130)

  0x10a1581c (vfs_mountroot+0x46c)

  0x1052f190 (im_preinitrc+0x260)

  0x10a0bb58 (DoCalllist+0xf0)

  0x1052ecf0 (main+0x28)

  0x109aef68 ($vstart+0x48)

  0x10217838 (istackatbase+0xfc)

End Of Stack

        i 0 pfn 0x3000 pages 0x5000

        i 1 pfn 0x10000 pages 0x8000

        i 2 pfn 0x880000 pages 0x4f8000

        i 3 pfn 0xff8000 pages 0x7000

*** Not enough CPUS for a compressed dump ***

 

*** A system crash has occurred. (See the above messages for details.)

*** The system is now preparing to dump physical memory to disk, for use

*** in debugging the crash.

 

*** The dump will be a SELECTIVE dump with

    compression OFF and concurrency OFF:  1942 of 20681 megabytes.

*** To change this dump type, press any key within 10 seconds.

 

*** Select one of the following dump types, by pressing the corresponding key:

C) Proceed with CURRENT dump configuration.

S) The dump will be a SELECTIVE dump with both compression and

    concurrency OFF: 1942 of 20681 megabytes.

P) The dump will be a PARTIAL dump with both compression and

    concurrency OFF: 8192 of 20681 megabytes.

    (A FULL dump is not possible.)

N) There will be NO DUMP performed.

*** Enter your selection now.

*** Dump disabled.  System rebooting.

 

I had to re-ingite in the end