HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

xmanager

 
rajesh73
Super Advisor

xmanager

Hi All

I have PArisc rp3440 server and os version is hp-ux 11.11. iam not able to connect thru xmanager(windows PC) to my server(hp-ux server).

pls any one help me very urgent.

Regds
rajesh
5 REPLIES
Steven Schweda
Honored Contributor

Re: xmanager

Why start a new thread for the same question?

http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1456885

It is the same question, isn't it?

> [...] iam not able [...]

Not a useful problem description. It does
not say what you did. It does not say what
happened when you did it.

> [...] xmanager(windows PC) [...]

Not a very detailed description of the
software on that system.
Horia Chirculescu
Honored Contributor

Re: xmanager

Search the forums for "xserver".

A lot of threads covered the same issue.

Best regards,
Horia.
Best regards from Romania,
Horia.
Jayakrishnan G Naik
Trusted Contributor

Re: xmanager

Hi Rajesh,

I have faced many issues related to the the connectivity using Xmanager, and rarely, few of them were similar, the issue (black screen), can occur due to more than one issue, so you need to check all the possibilities like

1) Does any firewalls in between
2) Does your xserver runnning?
3) Does it need some configuration to share xwindows.

4) does your /etc/hosts & nsswitch.conf have something to do with the issue. Put all necessary & correct entries here.

I didn't exactly remember, (as I faced it few years back) but few of those problems were mainly related to entries in /etc/hosts & /etc/nsswitch.conf

Thanks & Regards
Jayakrishnan G Naik
Jayakrishnan G Naik
Trusted Contributor

Re: xmanager

Hi Rajesh

To add to the above reply,

5) the issue can be with the need of environment variable DISPLAY

export DISPLAY=:0.0

Thanks & Regards
Jayakrishnan G Naik
Ismail Azad
Esteemed Contributor

Re: xmanager

Hi,

Adding to JGK, if in case you are connecting to the server from putty from a windows system, give the IP address of the windows system and not the HPUX server IP. Hope this helps. Remember, if you set the display variable incorrectly, even your sam TUI will behave strangely.

Regards
Read, read and read... Then read again until you read "between the lines".....