- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- WBEM PROTOCOL
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2017 07:13 AM
04-04-2017 07:13 AM
WBEM PROTOCOL
New SQL CLUSTER was added recently in our environment. But that is not perfectly discovered. It is showing under Major Clusters Tab. When i try to re-discover them, for a while the nodes are showing under the SQL CLUSTER and then disappears. When i see the Discovery results, it says that " HP SIM cannot communicate with these systems using the WBEM protocol.". I checked for the ports 5988/5989they doest show up.
Valueble information is appreciated.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2017 07:40 AM
04-04-2017 07:40 AM
Re: WBEM PROTOCOL
So you use WBEM to discover the servers. Can you run a identification for your server(s) and post the result here ?
Do you also have SNMP configured? You should only use SNMP or WBEM not both. The WBEM user should have enough rights on the servers ytou want to discover. You can use an admin account or use SIM to configure a non admin account for discovery.
Andrew