- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- HP Data Protector Express Basic Error 105 on Windo...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2012 11:28 PM
05-21-2012 11:28 PM
HP Data Protector Express Basic Error 105 on Windows 2008 R2
Hello,
I have installed HP Data Protector Express Basic on Windows 2008 R2 with an HP DAT320 USB.
With the software i can see the tape, erase data and format cartridge but i can't make a backup.
After the start the backup an error occur : Error 105 unsupported operation.
I can see the error occur after the system make a VSS. It seem the backup software can't make the VSS Snapshot ?
Have you any solutions for this trouble ?
Best Regards
Johan Tornay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-03-2012 08:09 AM
07-03-2012 08:09 AM
Re: HP Data Protector Express Basic Error 105 on Windows 2008 R2
Hi,
Normally these errors are caused when using EFI partition. The EFI partition is causing the jobs to fail, while generating disaster recovery information.
Add the following lines to the dpconfig.ini file:
(Default path: C:Program Files\HP\Data Protector Express\Config\)
Boot Configuration:
1. First stop DP Express service.
2. Open dpconfig.ini file and make the changes as mentioned above.
[disableVamObjects]
3. Save dpconfig.ini file.
4. Start DP Express service, and then check for backup job status.
Example of the DP Express config file after adding this entry is as follows:
[configuration]
nodeGuid={00001001-4EAE63EF-000B5A01-0003CADB}
nodeName=ML370G4G20U25
databaseServerAddress=localhost
isDatabaseServer=Yes
databaseServerName=Data Protector Express Storage Domain
skipCUIDeprecatedMsg=No
[disableVamObjects]