- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- 1533 in external case and SCSI Switch
StoreEver Tape Storage
1752777
Members
5930
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2002 10:47 AM
04-26-2002 10:47 AM
1533 in external case and SCSI Switch
I have a HP 1533A SCSI tape drive that I have put in a ANTEC datatank.
I have a question about setting the SCSI switch. The data tank does
have a switch on the back there are 4 wires (black, blue, yellow and
red) that come from the switch. On the back of the HP 1533A are
the normal jumpers for the SCSI ID setting. There are 5 pins in
a small enclosure above the jumpers. Does any one know the correct
method to enable the external SCSI ID switch?
Thanks
I have a question about setting the SCSI switch. The data tank does
have a switch on the back there are 4 wires (black, blue, yellow and
red) that come from the switch. On the back of the HP 1533A are
the normal jumpers for the SCSI ID setting. There are 5 pins in
a small enclosure above the jumpers. Does any one know the correct
method to enable the external SCSI ID switch?
Thanks
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2002 07:45 PM
04-26-2002 07:45 PM
Re: 1533 in external case and SCSI Switch
See my reply over in the other forum...
http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0x067a7d4cf554d611abdb0090277a778c,00.html
The journey IS the reward.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP