- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- 1U rackmount kit Power On issue after power fail (...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-11-2014 02:34 AM
06-11-2014 02:34 AM
1U rackmount kit Power On issue after power fail (no latch switch?)
We have a couple of 1U rackmount kits for Ultrium/Storever drives with each one Ultrium 448 SAS drive installed (we purchased the drives and rackmount kits seperately). They work fine but if the power is removed and restored the unit stays in standby and doesn't stay in "last state" or "always on" which is not good. Reading the quickspecs at page 4 it is written that this rack kit should have latch switch capability (I guess they mean that logically they will maintain the last state as the power on is a push button) though I fail to see how to enable it. The 1U rackmount kits are a few years old so maybe the PSU specs have changed over the years which would explain the difference.
Does anyone have any further info on the matter?
Thanks!