Arcserve E6300 SCSI error Proliant DL380/DLT

[Jon Dunster]

We have an E6300 Windows NT SCSI Port Error [ABSL:1200 CMD:0h]

On a DL380 with an internal 35/70 DLT drive.

Its just started coming up for no apparent reason (i.e. no hw/sw changes made.)

Any ideas anyone ?

[Andrej_6]

I suppose that your backup application is ARCserve. Reason for E6300 is usualy outdated SCSI driver (probably not your case) or hardware problem. You should try to replace SCSI cable then DLT drive and system board (embedded SCSI controller) at the end.

[Pete Simpson_1]

I had this same problem recently. An upgrade to the Adaptec SCSI driver fixed the problem. The driver on the system was the original Win2K driver that shipped with Windows 2000 Server. The new drivers, obtained from the Adaptec website, resolved the issue.