HPE Community
StoreEver Tape Storage
1752571 Members
5142 Online
108788 Solutions
New Discussion

Backupexec returns "failed to load"

 
Ayman Altounji
Valued Contributor

‎01-28-2001 04:00 PM

‎01-28-2001 04:00 PM

Backupexec returns "failed to load"

We are using BackupExec ver 7.3 running on NT4 and a four drive RAID configuration to pool four 35/70 drives. Every now and then, the job starts and "Loading....." appears in the "Job Monitor" window but the job never loads. when the job is cancelled, the log returns "Failed to load". Can't find anything on the Veritas site and thought one of you guys might have some input.
Wazup?
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎02-06-2001 04:00 PM

‎02-06-2001 04:00 PM

Re: Backupexec returns "failed to load"

Have you checked the individual cartridges you are using? Maybe one of them is bad... Other than that - there are probably a hundred variables involved.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.