Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

Boot Error after adding DLT4000

Andrew Moore_3
Occasional Advisor

Boot Error after adding DLT4000

When botting I get the following message: "1777-Slot1 Drive Array - Proliant Storage Enclosure Problem Detected. SCSI Port 2: Interupt Signal Inoperative - Check SCSI Cables. This is occuring on a Smart Array 5302-128 with firmware version 2.92.
That shouldn’t be a problem
3 REPLIES
Bharat Katkar
Honored Contributor

Re: Boot Error after adding DLT4000

Hi,
i guess this could be SCSI bus termination problem. Also check for SCSI cables and loose connections.
Regards,
You need to know a lot to actually know how little you know
Allan_24
Regular Advisor

Re: Boot Error after adding DLT4000

Try to use dedicated SCSI controller for your tape box. Basically, array controllers are designed to work more on active disk devices.

Cheers!
"You should be working"
Tim Schaffer
Occasional Advisor

Re: Boot Error after adding DLT4000

Thats correct, the 5300 series controller only supports internal hot plug tape drives. Unless the DLT4000 is connected to something else, that is your problem.