HPE Community
StoreEver Tape Storage
1752679 Members
5594 Online
108789 Solutions
New Discussion

Re: Can't LTO drives from rp7400

 
Raul_7
Occasional Advisor

‎06-05-2002 08:50 AM

‎06-05-2002 08:50 AM

Re: Can't LTO drives from rp7400

To all

Problem has been resolved. It looks like there is 1 default zone all brocade switches. Port "0" was not part of the default zone. HP CE configured Port "0" to be part of the default zone. It works fine.
Good things come to those who wait, "let the backups finish"
0 Kudos
Reply
Vincent Fleming
Honored Contributor

‎06-05-2002 12:19 PM

‎06-05-2002 12:19 PM

Re: Can't LTO drives from rp7400

Raul,

Thanks for posting the resolution! It's always helpful to see what works for debugging different problems.

For everyone else - there's some great advice in this article - if you haven't read the whole thread, you should - there are some great tricks in there!

No matter where you go, there you are.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.