Full steps for update NSR-M2402 firmware

[王峻]

Two way can update their firmware, one is by LTT, you can find the detail from the document I released: Update firmware for Ultrium 460 drive of ESL9322 in our forum.
Another way is by ftp, detail list below:
Download the firmware, and put it into one directory, example: g:\temp\firmware\5.6.06_fw_winston_x.dlx.
Get the configuration and trace records and save it follow these steps:
ftp 1.1.1.1 (default address of M2402)
user: root (default value of M2402)
password: password (default value of M2402)
bin
get m2402.cfg
get curtrace.txt
get purtrace.txt
put 5.6.06_fw_winston_x.dlx
bye
After transfer complete, the router M2402 will restart by itself, example:
Downloading DLX image via FTP or FC InBand interface.

System will reboot when download is complete.
Download of firmware image 5.6.06 version 5.6 to flash is complete.

*** Start System Cold Reboot!
Ethernet POST Test : PASSED
Fibre Channel POST(Module 0\Port 0): PASSED
Fibre Channel POST(Module 0\Port 1): PASSED
SCSI POST Test (Module 3\Port 0) : PASSED
SCSI POST Test (Module 3\Port 1) : PASSED
SCSI POST Test (Module 3\Port 2) : PASSED
SCSI POST Test (Module 3\Port 3) : PASSED

Target Name: Generic
User: target
Attaching network interface lnPci0... done.
Attached TCP/IP interface to lnPci unit 0
Attaching network interface lo0... done.
NFS client support not included.
SCSI bus 12 is up. Connect Mode: (LVD)
SCSI Controller is a 1010 Terminators On

SCSI bus 13 is up. Connect Mode: (LVD)
SCSI Controller is a 1010 Terminators On

SCSI bus 14 is up. Connect Mode: (LVD)
SCSI Controller is a 1010 Terminators On

SCSI bus 15 is up. Connect Mode: (LVD)
SCSI Controller is a 1010 Terminators On

Activating Interrupts for SCSI Module 3, bus 0
Activating Interrupts for SCSI Module 3, bus 1
Activating Interrupts for SCSI Module 3, bus 2
Activating Interrupts for SCSI Module 3, bus 3

HP StorageWorks Modular Router
5.6.06 A01RX5 262653-B21_K574CG0R6P20UX
01/18/2005 14:32:30
1) Perform Configuration
2) System Utilities
3) Display Trace and Assertion History
4) Reboot
5) Download a New Revision of The Firmware

Command >
After you can login into the M2402, please put the old configuration into it follow these steps:
ftp 1.1.1.1 (default address of M2402)
user: root (default value of M2402)
password: password (default value of M2402)
bin
put m2402.cfg
bye
Then login into the M2402, check device list and map, if it is ok, check the ESL9000 from OS side. If all ok, update complete.