Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

HP LTO Ultrium II Library MSL6060L2 FC

CARLOS SOUSA
Occasional Advisor

HP LTO Ultrium II Library MSL6060L2 FC

Hi,
Our environment: HP LTO Ultrium II Library MSL6060L2 FC, SUN V480 with Solaris 8 and JNI HBA FCE-6460.
The file /dev/kernel/st.conf has the following string="ULTRIUM = 1,0x7a,0,0xd639,4,0x00,0x00,0x00,0x40,3;"
Is it necessary change it to install the library ?
It's working perfectly with a HP SureStore Ultrium Library 2/20.
We will use EZFibre to install the Ultrium II Library; is it change that string automatically ?
3 REPLIES
Stf
Esteemed Contributor

Re: HP LTO Ultrium II Library MSL6060L2 FC

Hello,
you just have to install correctly your EZFibre, maybe the following link could be useful:
http://www.jni.com/OEM/oem.cfm?ID=4
and after that you just have to connect yoHP LTO Ultrium II Library. When you start the server you make a stop A to access the open boot prom, and at the 'ok' prompt you type 'boot -r' and the LTO would be configure...

Stf
CARLOS SOUSA
Occasional Advisor

Re: HP LTO Ultrium II Library MSL6060L2 FC

Hi Lenud,
Thanks for your reply. You mean we must install EZFibre and only after that connect the library ? After the "boot -r" I think we must run EZFibre to configure the library. Is this the correct order of actions ?
Stf
Esteemed Contributor

Re: HP LTO Ultrium II Library MSL6060L2 FC

Yes that's it, if the LTO is not automatically configured, I think you should configure it through EZFibre.