StoreEver Tape Storage
1748272 Members
4099 Online
108760 Solutions
New Discussion

LT&T: first scan with Ultrium 920 SCSI completes with errors

 
Clemens Kussbach
New Member

LT&T: first scan with Ultrium 920 SCSI completes with errors

I am encountering the following problem with a newly installed ultrium 920 scsi-drive: when starting LT&T, the initial hardware scan results in a "scan completed with errors". The drive is however found and there is no visible clue what kind of error really has occurred.
Previously the LT&T Installation Check run without any problem.
Here some configuration details:
Device: HP StorageWorks Ultrium 920 (1) SCSI Tape Drive in 1U Rack-mount Kit
Controller: HP SC11Xe Host Bus Adapter
1 REPLY 1
TapeDrive Killer
Trusted Contributor

Re: LT&T: first scan with Ultrium 920 SCSI completes with errors

This is normal if you are able to see the tape drive with a blue color then it was detected properly if not make sure backup services are stopped as well as removable storage.

Pablo Alvarado Siles
One drink away from sleeping on the pavement