HPE Community
StoreEver Tape Storage
1751791 Members
4985 Online
108781 Solutions
New Discussion юеВ

Legacy disk array connectivity to SAN

 
Asghar Ghori
Occasional Advisor

тАО10-24-2005 12:35 PM

тАО10-24-2005 12:35 PM

Legacy disk array connectivity to SAN

Hi there,

I need to connect a small tape library to SAN through a fc/scsi router. I have connected the library to the router and the router to my Brocade 3800 switch. I have 4 hp servers running hpux 11i. I have run ioscan/insf but no drives are visible. There is no zoning at the switch level.

Can anyone help. I guess some configuration is required at the router level.

Thanks
0 Kudos
Reply
2 REPLIES 2
Steven Clementi
Honored Contributor

тАО10-24-2005 12:39 PM

тАО10-24-2005 12:39 PM

Re: Legacy disk array connectivity to SAN

Asghar:

The fc/scsi router might need to be configured to present the scsi drives on the fibre.

What model router do you have?


Steven
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
0 Kudos
Reply
Alzhy
Honored Contributor

тАО10-25-2005 02:57 AM

тАО10-25-2005 02:57 AM

Re: Legacy disk array connectivity to SAN

I agree.

If it is a legacy Compaq FCTC (I or II) -- I can help. If it is another brand/flavour -- then refer to the documentation. Usually those storage routers have a nice Web interface in addition to telnet and serial config options.
Hakuna Matata.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.