Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

MSL 5000 series Picker Jammed error code 3100

MSL 5000 series Picker Jammed error code 3100

MSL Library 5000 series with two LTO1 drives, had hanged with a fault code "Picker Jammed Hard code 3100 " , a message lead to reboot the library with library initialization status is offered only ,,, the robot and moving arm had stopped and cannot be moved even when reboot the library ,,, what can i do ????

3 REPLIES
Joseph T. Wyckoff
Honored Contributor

Re: MSL 5000 series Picker Jammed error code 3100

If your hardware is under support or warranty, place a hardware call.

If your hardware is not under support or warranty, find some money... and place a hardware call.

Post in a tape hardware forum, rather than a tape software forum.

Good Luck.
Omniback and NT problems? double check name resolution, DNS/HOSTS...
Luk Vandenbussche
Honored Contributor

Re: MSL 5000 series Picker Jammed error code 3100

Rob Leadbeater
Honored Contributor

Re: MSL 5000 series Picker Jammed error code 3100

Hi,

The full description of the error according to the Maintenance and Service Guide is:

The picker jammed during a bin stow operation

Steps to recover are:

1. Press Enter to reboot.
2. Cycle power to the library or reboot by using the LCD touch display.
3. Make sure there are no obstructions inside the library (all cartridges are in magazines).
4. Make sure cartridges are fully inserted in the magazine(s).

If you've done all that, then log a fault call as previously advised.

Cheers,

Rob

P.S. Joseph: Who said this was a software only forum ??