HPE Community
StoreEver Tape Storage
1752288 Members
4527 Online
108786 Solutions
New Discussion юеВ

MSL 6000 is not showing all ultrium in linux

 
renjith
Occasional Advisor

тАО11-15-2006 09:18 PM

тАО11-15-2006 09:18 PM

MSL 6000 is not showing all ultrium in linux

MSL 6000 is only showing one ultrium in /proc/scsi/scsi (having 4 ultrium)
linux ES 3 latest update
one nsr is showing MSL 6000,another nsr is showing one ultrium
0 Kudos
Reply
4 REPLIES 4
Torsten.
Acclaimed Contributor

тАО11-15-2006 11:33 PM

тАО11-15-2006 11:33 PM

Re: MSL 6000 is not showing all ultrium in linux

Did you check the mapping of the NSR?
The NSR need to see all devices (2 drives each, of course)

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
renjith
Occasional Advisor

тАО11-16-2006 12:43 AM

тАО11-16-2006 12:43 AM

Re: MSL 6000 is not showing all ultrium in linux

two drives are maped for each NSR
0 Kudos
Reply
renjith
Occasional Advisor

тАО11-16-2006 03:23 AM

тАО11-16-2006 03:23 AM

Re: MSL 6000 is not showing all ultrium in linux

in nsr maping each NSR is maped to two ultrium
only one device file is get created /dev/sg2 for drive3
0 Kudos
Reply
renjith
Occasional Advisor

тАО11-16-2006 03:26 AM

тАО11-16-2006 03:26 AM

Re: MSL 6000 is not showing all ultrium in linux

hai all
can any one tell how MSL 6060 is configuring in
RHEL 3 ,is it required any driver
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.