Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

MSL4048 Aborts backup when a magazine is ejected

Irishhooligan
Occasional Visitor

MSL4048 Aborts backup when a magazine is ejected

Hi,

 

We recently switched from a MSL6030 to a MSL4048 and we use Data Protector 6.1.  Each library uses two tape drives.   With the MSL6030 if a backup is running in drive 2 and I removed the other magazine (not the magazine with the tape that is being used in drive 2) the backup would continue running without issue.  With the MSL4048 if I try the same process noted above it aborts the backup that is running to drive 2. When the backup aborts it leaves the tape in drive 2 and will not auto eject the tape to the slot,  I have to manually move the media from the drive to a open slot.  I know with the MSL4048 once a magazine is ejected all robotics are halted until all magazines are in place.  But why will it abort a backup that is currently running in a drive.   Any help is greatly appreciated!!

 

Thanks in advance!!

1 REPLY
Torsten.
Acclaimed Contributor

Re: MSL4048 Aborts backup when a magazine is ejected

First I would try with newest firmware (7.80) - update the drives too if needed!

 

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=12169&prodSeriesId=3936307&swItem=co-38806-43&prodNameId=3454509&swEnvOID=1005&swLang=8&taskId=135&mode=4&idx=0


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!