- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- MSL4048 Backup Media Server Issue
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2011 12:35 PM
07-16-2011 12:35 PM
MSL4048 Backup Media Server Issue
Hi,
I have a MSL4048 with four 8G FC drives. All four connected to two different Brocade switches (divided two by two).
The backup media server is dl360 g5, 12 gb memory, windows 2008 R2 , with one HP 82B (Brocade 8 gbps dual port card , 825). Each port of 82B is connected to that two san switches one by one.
The problem is, when I restart the server, it never comes back, its always waits at "Starting windows"..
When I disconnect msl4048 from the san switch, I can boot the server successfully. (of course the same, when I disconnect the server from san switch, it is able to boot too)
The zoning on san switches has been reviewed and found to be correct.
Is there a known problem? Or do you have any suggestions?
Thank you.