Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

MSL4048 does not apperar in HP-UX system

MSL4048 does not apperar in HP-UX system

It was installed recently a MSL4048 in a HP-UX 11.00 system. The Hardware Address ( e.g. /dev/rac/cxtydw isn´t present on ioscan result.

Dows anybody knows something about that ?
Alex
8 REPLIES
Torsten.
Acclaimed Contributor

Re: MSL4048 does not apperar in HP-UX system

how about an "ioscan -fn" output?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MSL4048 does not apperar in HP-UX system

After ioscan -fn , only the two tapes appears.

LTO -1
LTO -2

But the Library doesn´t !!! /dev/rac/cxtwdy !
Alex
Torsten.
Acclaimed Contributor

Re: MSL4048 does not apperar in HP-UX system

Could you post this output?

(Sorry, was not clear enough)

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MSL4048 does not apperar in HP-UX system

See attached.
Alex
Torsten.
Acclaimed Contributor

Re: MSL4048 does not apperar in HP-UX system

As exected, the driver is missing:

unknown -1 0/5/0/0.1.2.255.0.0.1 UNCLAIMED UNKNOWN HP MSL G3 Series

add the schgr driver to the kernel and reboot.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MSL4048 does not apperar in HP-UX system

Do you know how i can do this ?
Add driver to kernel.
Alex
Torsten.
Acclaimed Contributor

Re: MSL4048 does not apperar in HP-UX system

open SAM -> kernel -> add driver (schgr) -> process new kernel -> reboot

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MSL4048 does not apperar in HP-UX system

it´s ok
Alex