MSL6000 discovery problem

[amer_3]

hi
i have added the wwn as it's been recomanded by hp.
i have done as u sujested but the same.
i have attahed the report and the out put of the commands in the switch.
im sorry but im new in this thats why i have alot of problems.
thanks alot

[amer_3]

currant report

[amer_3]

hi

i have done a farmware up date for the router and reseted the confguration but still the same

amer

[Marino Meloni_1]

the zone do not appear complete, you have to add in the backup zone, the library and the HBA of the servers you want they communicate with the library, not only the library

marino

[Marino Meloni_1]

best will be to create a Tape_Zone for each Host that need to see the library:

Zone: TAPE_LIBRARY_host1
Zone Member: Domain 1, Port 3
Zone Member: host1 (alias, wwn or Dom/Port )

Zone: TAPE_LIBRARY_host2
Zone Member: Domain 1, Port 3
Zone Member: host2 (alias, wwn or Dom/Port )

etc...

this will keep all commands separeted from each server and from Disk devices


after you enable and save your zone, the WWN of the hosts should appear in the NSR after a FC discovery command.

THen apply the procedure I described before, and you should be able to assign the map to each host discovered

marino

[amer_3]

hi
i have done the following:
1- i have created seperate zones for each server with the MSL
2-i have tried another SAN switch and done the config.
3-i have dont the port speed for 2g.
4- i have created a map on the NSR for the HP ux servers and removed the NSR, priority target/buss.

im still can not see the servers

amer

[Marino Meloni_1]

have you run an ioscan on the server in oder to populate the NSR discovery window?

[amer_3]

hi
i have just done this:
1-i have created a zone and added the MSL and a windows server to it, when i checked the NSR it ditecte it at the hostsand i could and it to a map and i have discoverd the MSL at the windows server.
2- but when i do a FC discovery it dose not discover the server.

i dont know but is there any thing i should do in the UNIX servers.

amer

[Marino Meloni_1]

Amer,
my knowledge on Unix is limited, but if now you could configure and see the library in the Windows server, this mean all is working.
Be sure you do not have dual path on the servers, and you zoned the path inactive one

marino

[Mohanasundaram_1]

as per HP's SAN checklist, seperate maps should be created for windows and unix.

Pls follow that checklist to create maps.