Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

More infomation on " SCSI controller not starting for DLT drive"

Ayman Altounji
Valued Contributor

More infomation on " SCSI controller not starting for DLT drive"

I download sp10754.
Then fallowed the steps below.

1. Start/setting/control panel
2. Tape device
3. Add/Have disk ........selected the path were the files are located.
4. rebooted the machine.

Once the server has been restarted and I logon to the server I recieved a message that a service has failed to start. The following is from Event viewer:
The following boot-start or system-start driver(s) failed to load:
cdlt7n4i

I'm very frustrated ....can anyone help!
5 REPLIES
Ayman Altounji
Valued Contributor

Re: More infomation on " SCSI controller not starting for DLT drive"

What specific DLT drive do you have?
Ayman Altounji
Valued Contributor

Re: More infomation on " SCSI controller not starting for DLT drive"

The DLT drive is a 35/70 and its attached to a dl380 and I also have another server 1850r that is using the same type of DLT drive expiencing the same problem.
Ayman Altounji
Valued Contributor

Re: More infomation on " SCSI controller not starting for DLT drive"

I had same problem. Fix was to uninstall the compaq scsi drivers (cpq32fs2), uninstall tape driver, then reinstall in the reverse order, ie tape driver then compaq scsi driver.
Ayman Altounji
Valued Contributor

Re: More infomation on " SCSI controller not starting for DLT drive"

Thanks for the bit of info but I have a question for you? Was that fix on a DL380 system or a 1850r system. The reason for the ? There are different motherboard architectures. A fix may work on one type of system but not on the other? Can you give me more info?
Ayman Altounji
Valued Contributor

Re: More infomation on " SCSI controller not starting for DLT drive"

That fix was for the 1850R and it is attached to a TL891 Library. Good Luck!