Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

NSR does not connect to brocade

antonio difruscia
Regular Advisor

NSR does not connect to brocade

I have a MSL6000 with a HP e1200-320 4G Interface Controller. I have this NSR connected to a brocade 2/16. I have set the NSR Performance Mode set to 2g. Discovery Mode is set to Discovery on Link UP. I can not get the link status up. When I do a switchshow it displays port 10: id N2 In_Sync
I have tried portdisable 10 and portenable 10
with no luck.. I have tried 2 different ports
with the same results.

thanks
TonyD


4 REPLIES
Patrick Terlisten
Honored Contributor

Re: NSR does not connect to brocade

Hello,

try "portCfgSpeed 10 2G" to set the switchport to 2G.

Best regards,
Patrick
Best regards,
Patrick
antonio difruscia
Regular Advisor

Re: NSR does not connect to brocade

I have already tried that, sorry I forgot to mention that..

thanks
TonyD
Marino Meloni_1
Honored Contributor

Re: NSR does not connect to brocade

Have you already replaced the cable and the switch port?
Can you attach here a full nsr report?
form the left hand menu, select report and save as HTML single file
I will try to have a look
antonio difruscia
Regular Advisor

Re: NSR does not connect to brocade

after changing the cable for the second time we finally got it up on the san

thanks
TonyD