- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- Pass Thru Hub (Router, 9-port)
StoreEver Tape Storage
1752801
Members
5478
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-12-2004 06:43 AM
02-12-2004 06:43 AM
Pass Thru Hub (Router, 9-port)
Hi,
Without a pass thru hub can you configure a master/slave using a generic hub or switch?
I have a spare hub and switch and realised my PTM kit came without this hub.And am wondering if i can use the spare hub/switch while i get the hub from HP
Has anyone been able to do this?
Thanks!
Shaun
Without a pass thru hub can you configure a master/slave using a generic hub or switch?
I have a spare hub and switch and realised my PTM kit came without this hub.And am wondering if i can use the spare hub/switch while i get the hub from HP
Has anyone been able to do this?
Thanks!
Shaun
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2004 08:22 PM
02-13-2004 08:22 PM
Re: Pass Thru Hub (Router, 9-port)
I don't think there is anything special about the hub that comes with the pass-through (PTM) kit. It should be a standardd 8-port hub. Give your generic hub a try - can't hurt.
You do need the hub for the master to talk with the slave.
Also, update to 4.23 firmware (on both units) before putting them together as master/slave. If you are on 4.08 in a master/slave configuration, firmware updates will fail (until you separate the two).
You do need the hub for the master to talk with the slave.
Also, update to 4.23 firmware (on both units) before putting them together as master/slave. If you are on 4.08 in a master/slave configuration, firmware updates will fail (until you separate the two).
The journey IS the reward.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP