Robotic Libray Hardware error

[Debbiek03]

Vendor: HP
Product ID: C7145
Library Type: Change FS=1
Serial # HP C7145USOBH0049

Last few weeks having error:

Hard Error : Failed to Unload tape from Drive. Command Sent to drive controller timed out.

Failed Move from Drive 1 to Storage Slot 1

CODE 63, Qualifier 108, Sequence- 102,134,54,53,105,104

I manually try to move the tape from drive to storage slot. Move Fails. Power down and up again. Performs self test. Manually move tape works then. Any help appreciated.

Thanks

[Ivan Ferreira]

Check your firmware version. I had a similar problem with a robotic and was a firmware problem. Ensure that you are using the latest firmware version.

[Torsten.]

Sounds like a bad drive or a bad picker. Somebody has to investigate this.

[Debbiek03]

Bad Picker? Are there technicians that service the drives or do I get a new one? Is it easy to install?

[Torsten.]

First you should install LTT to check the firmware level and performe some load/unload tests.

http://www.hp.com/support/tapetools

[aleks mindlin]

From "Administration" menu there are 2 tests available:
1. will randomly move tapes from slot - to - slot without affecting the drive. If it pass multiple times --> your picker is OK.
2. randomly moves tapes from slot - to - drive.

[Debbiek03]

I moved tapes from slot to slot. It seems the picker is OK.. I use Veritas Backup Exec 10.0... it shows the HP1 offline in the software and all jobs are failing "no idle devices"... not sure what to do. Thanks for help

[aleks mindlin]

Have you run , which randomly moves tapes from slot - to - drive?

[Debbiek03]

I cannot get into the Administrator on the machines display... it is password protected, and I did not setup the drive in the first place, so don't know the password to get in. I installed the HP software to do testing... is there a wellness test in that program?

[Jaclyn Rothe]

Command sent to drive failed... can be indicative the library controller card is bad.

Try flashing firmware... if this does not correct the issue or if the flash fails (which it likely will) note what portion of the update it failed on that is most likely the cause of your issue.

I have a theory it will fail on the library controller card.

Also try reseating the drive(s) and check your cables have not been bumped or come loose.