StoreEver Tape Storage
1748268 Members
3417 Online
108760 Solutions
New Discussion юеВ

SDLT 110/220 won't work!

 
Sean_114
Occasional Contributor

SDLT 110/220 won't work!

I can't get backups to work to this SDLT! OS is 2003 Standard, scsi card is adaptec 2940UW. OS sees DLT just fine..mounts drive when in ntbackup..no prob. But when you try a backup, fails immediately with "device reported an error on a request to MS_UpdateNtmsOmidinfo error 5"

I found an article that said to make sure that the RPC service, under the logon tab, had the 'allow service to interact with desktop' checkbox cleared. It was....any ideas???
2 REPLIES 2
Stuart Whitby
Trusted Contributor

Re: SDLT 110/220 won't work!

Just a guess, but are you running this as an admin? Error 5 from the OS side is access denied - maybe you don't have permissions to write to the drive.
A sysadmin should never cross his fingers in the hope commands will work. Makes for a lot of mistakes while typing.
Claudio Ruzza_1
Valued Contributor

Re: SDLT 110/220 won't work!

Which backup sw are you using?
Software drivers to be used strictly depend upon the bu sw.
Let us know
Claudio