- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- TL891/892 Serial Cable
StoreEver Tape Storage
1748049
Members
4697
Online
108757
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-21-2001 04:00 PM
тАО02-21-2001 04:00 PM
TL891/892 Serial Cable
Does anyone know the pinouts for the Fibre Channel Tape Controller II RS232 serial cable? This cable is used to configure the controller through the serial port on a workstation.
Thanks
Thanks
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-22-2001 04:00 PM
тАО02-22-2001 04:00 PM
Re: TL891/892 Serial Cable
The user manual .pdf has a good picture to refer to for the RJ-11 side, The female DB9 connectors should have numbers on them. Use a 6 wire cable, cut 'n connect to the DB9: 2TX, 3RX, 5GND, 7RTS, 8CTS. Example: #2 on the RJ-11 is GND, twist it with the #5 on the DB9 - check it with a continuity tester. If it does'nt work, try swapping the TX & RX. reboot the FCTC to get in - hitting "enter several times" never worked even after I finally got it right. Good Ref: www.pin-outs.com/datasheet_11.html
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-04-2001 04:00 PM
тАО04-04-2001 04:00 PM
Re: TL891/892 Serial Cable
Currently, support for Digital Alpha and higher-end Storageworks products is not on this forum. If you are in the US or Canada, call 1-800-354-9000. If you are elsewhere, please contact our nearest offices for support information or check any service contracts you may have for the product in question.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP