- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- TL891 master/slave problem
StoreEver Tape Storage
1748209
Members
2879
Online
108759
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2003 05:03 AM
07-23-2003 05:03 AM
TL891 master/slave problem
I have a TL891 with the base unit and the expansion unit. I need to run the base unit standalone, but it is set to slave.
How do I break the relationship and make the base unit a master again?
How do I break the relationship and make the base unit a master again?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-24-2003 12:58 AM
07-24-2003 12:58 AM
Re: TL891 master/slave problem
To set the library from Slave to Standalone mode from the Library front panel follow the steps below:
- Select CONFIGURATION MENU
- Scroll down to SET SPECIAL CONFIG.
From the Alternate Config option
- Select STANDALONE
You may need to power cycle the library for the changes to take effect.
Thoe other thing you'll need to check is the passthrough plate, if you have the library operating as standalone then the passthrough plate will probably need to be put back in place.
- Select CONFIGURATION MENU
- Scroll down to SET SPECIAL CONFIG.
From the Alternate Config option
- Select STANDALONE
You may need to power cycle the library for the changes to take effect.
Thoe other thing you'll need to check is the passthrough plate, if you have the library operating as standalone then the passthrough plate will probably need to be put back in place.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP