Tape Libraries and Drives
cancel
Showing results for 
Search instead for 
Did you mean: 

big problem with hp surestore 20/700

sven1
Occasional Contributor

big problem with hp surestore 20/700

dear suppert team,

i have a problem with our surestore tape library 20/700.

we recieved sometimes an error message from our library, THETA and reach errors.

i think it must have something to do with the theta motor from the robot arm...
but if we switch off the library for 30 and restart it everything is fine...

if we restart the library the same theta and reach error messages are in the log file and the robot hand stops at init procedure.

if you need further informations like the error codes from fsc contact me.

i hope someone can help me.

with regards

Sven
2 REPLIES
ANNIE
Trusted Contributor

Re: big problem with hp surestore 20/700

Hi,
What exact error codes you are receiving. Can you mention it?

Check out this link:
http://www.erchi.com/hp_sides/oars/DISK1_CURRENT/ADVISORIES/SERVICE/OT041116_SW02.HTML
If you get some help out of it then let me know.

Thanks
----------------------------------------------------------------------------------------------------------------------------------
** If found useful, please assign kudos located at the left hand side.
Thanks.

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
sven1
Occasional Contributor

Re: big problem with hp surestore 20/700

Hi anni,

i can only remind me of the error code 3099 theta... the hand stops in init procedure at drive0, the first drive near bottom. if the hand move on she stops after initialisation of cleaning drives at front door.

firmware update is already installed.

I think its the motor on the hand/camera module which grap and eject the cartrige.

with regards and hope for reply:)

Sven