HPE Community
StoreEver Tape Storage
1752612 Members
4423 Online
108788 Solutions
New Discussion юеВ

Re: drive no longer recognized

 
Ayman Altounji
Valued Contributor

тАО01-05-2001 04:00 PM

тАО01-05-2001 04:00 PM

drive no longer recognized

Hi, since I've rackmounted my formally pedestral PL3000, the internal DLT 15/30 drive is no longer recognized by scsi scan and all of the left hand side lights on the drive are blinking. Changing SCSI adapter and / or cable did not show any positive results.
I'm getting desperate !
0 Kudos
Reply
3 REPLIES 3
Ayman Altounji
Valued Contributor

тАО03-30-2001 04:00 PM

тАО03-30-2001 04:00 PM

Re: drive no longer recognized

I am having the same problem with a 35/70 DDT drive in a PL3000. It was working fine, and then the lights on the left hand side just started blinking after a rebut. I have changed drives and cables, still with no resolution.
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО04-04-2001 04:00 PM

тАО04-04-2001 04:00 PM

Re: drive no longer recognized

Replace the 15/30 DLT drive .

Run diags on the system with the 35/70 DLT .
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО05-13-2001 04:00 PM

тАО05-13-2001 04:00 PM

Re: drive no longer recognized

I've got the same problem with two 35/70 DLT drives out of the four in a Tape Array II chassis on a Proliant 7000 server, that were working before and are now not even recognized as devices on a SCSI chain.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.