StoreEver Tape Storage
1752579
Members
4069
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2009 04:28 AM
10-13-2009 04:28 AM
error
there is a backup tape in Drive 0 and we canâ t take it out. It shows that the drive is in use but there is no job running
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2009 05:12 AM
10-13-2009 05:12 AM
Re: error
when a host lost connectivity to a tape drive, it may stay in reserved mode, and then you cannot eject the drive anymore from the backup application.
The way to go is to clear the "reservation " flag in the drive
you can use the front panel of the library to shut down and then up the drive, or you can just power down * wait 30 seconds then power up the library. this usually clear up this condition, then from the front panel you can unload the drive
If the drive is not is use anymore after this sequence and the tape cannot be ejected, it may be the drive or tape is defective and cannot be ejected because something is broken, but you will receive some info about a hw issue, on the drive led or on the rmi
The way to go is to clear the "reservation " flag in the drive
you can use the front panel of the library to shut down and then up the drive, or you can just power down * wait 30 seconds then power up the library. this usually clear up this condition, then from the front panel you can unload the drive
If the drive is not is use anymore after this sequence and the tape cannot be ejected, it may be the drive or tape is defective and cannot be ejected because something is broken, but you will receive some info about a hw issue, on the drive led or on the rmi
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP