HPE Community
StoreEver Tape Storage
1752587 Members
4076 Online
108788 Solutions
New Discussion юеВ

esl322-e interface manager I230

 
john briggs_2
Occasional Contributor

тАО01-19-2008 04:53 PM

тАО01-19-2008 04:53 PM

esl322-e interface manager I230

After upgrading an esl322-e to I230, and robotics to 6.2.0 and interface controllers to 5936, commandview tl 2.3 correctly shows upgrade status of library however LTT 4.4 shows the robotics still at version 5.10.
OCP and cli show library at 6.2.0.
Why is LTT finding 5.10 which was the previous code.
0 Kudos
2 REPLIES 2
Bryce Perekrestenko
HPE Pro

тАО01-22-2008 12:15 PM

тАО01-22-2008 12:15 PM

Re: esl322-e interface manager I230

Hi John,
Please attach a LTT Support ticket for the library. We need to investigate this further to see if some kind of caching is happening which may result in LTT reporting the old firmware version for the library.

Regards,

Bryce
I work for HPE.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
0 Kudos
john briggs_2
Occasional Contributor

тАО01-24-2008 03:29 AM

тАО01-24-2008 03:29 AM

Re: esl322-e interface manager I230

customer had rezoned san and although commandview tl was seeing correct library at 2.3, ltt was scanning another library at a lower rev.
Please remove this from the forum
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.