TruCluster
cancel
Showing results for 
Search instead for 
Did you mean: 

Please, help with following error.

Tim_SW
Advisor

Please, help with following error.

clubase: configured
mchan0: Scatter gather space allocated at c0000000
mchan0: mchan_delay_deassert_put - mcport_ptr = 42400000
mchan0: mchan_delay_deassert_put - initial lcsr = 878
mchan0: mchan_delay_deassert_put has deasserted PUT lcsr = 78
mchan0: mchan_delay_deassert_put - after enable interrupts lcsr = 78
mchan0: mchan_delay_deassert_put - after setting OLEN mcport_ptr = 72400000 lcsr_ptr = 184078
dlmsl: configured
drd: configured.
cnxagent: configured
dlm: configured.

.
.
.

mchan0: heartbeat started
mchan0: lcsr = 184078 mcport = 72400000
mchan0: mchan_delay_ctlr_online - node id = 0
mchan0 - mchan_delay_ctlr_online - mcport = 72400000
mchan0: old node state = 0 new node_state = 3
mchan0: Log to Binary Error log ... error = 1801
mchan0: node 1 has come online
mchan0: mchan_delay_ctlr_online - call's online handler
rm_sw_init: begin MC initialization.
rm_boot_am_i_alone: entered
checking for existing memory channel nodes

.
.
.

unresponsive mc nodes - waiting for node mask 2

For regret, I cannot overcome that.
I have two nodes. Just point me either transmition or values of the register wrong.

Who is known it well?

Thanks to everybody who can help.
3 REPLIES
Tim_SW
Advisor

Re: Please, help with following error.

The problem is what I should to do, that second node has booted?
Rob Leadbeater
Honored Contributor

Re: Please, help with following error.

Hi,

Can you explain the context of your question please...

What is the problem you're trying to solve ?

Posting a few error messages without letting us know details of the hardware setup, operating system etc isn't going to get very far...

Cheers,

Rob
cnb
Honored Contributor

Re: Please, help with following error.

Hi,

"unresponsive mc nodes - waiting for node mask 2"

See section A5:
http://h30097.www3.hp.com/docs/cluster_doc/cluster_16/TCR_ADM/RRRMSSGS.HTM

This appears to indicate that MC Node 0 is waiting for MC Node 1 to completly come all the way up. It isn't seeing the other mc node (bent pin in cable or bad card?) up after initial online.

Check the LEDs on the CCMAB controllers BOTH LEDs need to be ON on each CMMAB when communicating with each other with the system software booted. If only 1 LED is on then that CCMAB isn't ONLINE to the host.

Here's a sample init process:

http://alpha-supernova.dev.filibeto.org/lib/cluster/1.5/TCR_INST/PPCNSLMS.HTM

Can you post SHOW FRU and SHOW CONFIG from SRM?


Did the low level mc_diag and mc_cable test successfully?

Please also see these threads:

http://h30097.www3.hp.com/docs/cluster_doc/cluster_16/TCR_HWCFG/CHMCXXXX.HTM#mc-adapter-reqs


http://h30097.www3.hp.com/docs/cluster_doc/cluster_16/TCR_HWCFG/CHMNTXXX.HTM#maint-interconnects

Specifically Section 8.9.1

Can you post both binary.errlog files?

hth,