UCMDB and UD Practitioners Forum (Previously CMS)
Showing results for 
Search instead for 
Do you mean 

AM to UD integration

Valued Contributor

AM to UD integration

The SACM doc mention that to use the fixed_values.txt in the AM adapter to control the domain of IP address being populate from AM.


When populating IP address data from AM to UCMDB, the IpAddress:routing_domain attribute
value of the IP Address CI Type is populated with DefaultDomain.
This file allows you to change the default value for the attribute.

 

The value of fixed_values:


Created By AM Integration: DS_AM Integration_AM Population Job 930

#entity[<entityName>] attribute[<attributeName>] value[<value>]

#entity[ip_address] attribute[routing_domain] value[${DefaultDomain}]

entity[ip_address] attribute[routing_domain] value[${USDomain}]

 

I tried with the above change and IpAddress is still being populate with DefaultDomain. What am i doing wrong? Is my syntax correct or is there something else i need to do? 

 

Thank you

3 REPLIES
HPE Expert

Re: AM to UD integration

As far as I know ${} in  [${USDomain}] is call for variable. Try to use [USDomain] or ["USDomain"].

Regards
-Dmitry Gomel, PMP
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Click the Like button at the bottom to say 'Thanks'.
Valued Contributor

Re: AM to UD integration

Yea i tried with both variation also tried ['USDomain'] , but doesnt seem to work 

HPE Expert

Re: AM to UD integration

Sorry for asking obvious thing, but did you try without isolation - [USDomain]?

If yes please open support case, will go over settings during the Webex.

Regards
-Dmitry Gomel, PMP
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Click the Like button at the bottom to say 'Thanks'.
//Add this to "OnDomLoad" event