WAN Routing
1748040 Members
5103 Online
108757 Solutions
New Discussion

ISP link failover configuraiton between two ISP

 
Muthukumar1
Frequent Advisor

ISP link failover configuraiton between two ISP

Hi team,

           We have 5945 4 slot switch and need to configured ISP failover configuration betwenn two ISP's . Could you suggest configuraiton document/ sample configuraiton.

same like as IP sla confifuraiton on cisco switch..

Regards

Muthukumar

4 REPLIES 4
Ivan_B
HPE Pro

Re: ISP link failover configuraiton between two ISP

Hi @Muthukumar1 !

IP SLA in Cisco is analogue to Comware's NQA. You need to configure NQA with a ping (for example) and then associate that NQA to a static route through Track. Seems you know IP SLA so I think you will get the idea about NQA and Track with no issues. Check it here  https://community.hpe.com/t5/comware-based/acl-to-block-inter-vlan-traffic/m-p/7098842 , page 234, " Configuring Track". If you need more information about NQA, check the Network Management and Monitoring Configurtion Guide - https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00052908en_us

Hope it helps!

 

I am an HPE employee

Accept or Kudo

Muthukumar1
Frequent Advisor

Re: ISP link failover configuraiton between two ISP

Hi,

Thanks for your guidence and can i get sample diagram with configuration example?

Thanks

Muthukumar

 

Ivan_B
HPE Pro

Re: ISP link failover configuraiton between two ISP

Did you have time to read the guides I've sent you? I think they have all you need.

I am an HPE employee

Accept or Kudo

Muthukumar1
Frequent Advisor

Re: ISP link failover configuraiton between two ISP

HI,

     I am reading the document and this is new project requirements and proactive i am going through all the documents as customer new requirements. still not applicable the configuration since material will deliver by next week. If any challenging on this surely i will ping you.

Thanks

Muthukumar